QLA Turbo

Click here to see our E-catalogue or download pdf

QLA-Turbo is the heaviest of our cutting lines and is offered in three different widths: 1050, 1250, or 1550 mm (40”, 49”, or 61”). This cutting line can be delivered with modules for special tasks like punching, notching, embossing, profiling, or for adding protecting foil. 

For handling of the cut-off sheets QLA-Turbo can be supplied with stacking and transport systems for fully automatic continuous operation.

The standard line comprises:

Straightening unit with 7 straightening rolls. The achievable straightness is in accordance with DIN 10133 for cold-rolled fine sheets.

Feeding unit with 2 sets of feeding rolls – each with one steel roll and one rubber coated roll. One set is placed before and one set after the straightening rolls. The feeding speed is 30 m/min. (90 ft/min.), and the feeding accuracy +/- 0,3 mm/meter (0.015”/yard). As standard feeding rolls are activated and deactivated manually.

Slitting unit – as standard with 2 pairs of slitting blades corresponding to the maximum nominal capacity of the line. If the number of slitting blades is increased the capacity of the line decreases correspondingly. The slitting blades are activated and deactivated manually.

Cutting unit – a mechanical shear in special execution. The material is efficiently held by a hold down unit with rubber coating. The blades are turnable which ensures a long life time.

Control - with touch screen. The control is programmable and can be used in manual or automatic operation.

Decoilers and other modules: please refer to pages QLA Decoilers and QLA Stacking Units.

7 straightening rolls

2 sets of feeding rolls

feeding speed 30 m/min. (90 ft/min.)

measuring accuracy +/- 0,3 mm/m (0.015”/yd)

Slitting unit:

2 pairs of slitting blades

manual activation and deactivation

Motorized shear

Double edged blades for mild steel and stainless steel

Cutting speed max. 60 cuts/min.


Control unit:

Touch Screen

programmable

manual or automatic operation

The nominal capacity of the cutting line is stated for use of 2 pairs of slitting blades in material with a tensile strength of 400 N/mm2 - 58000 lbf/in² (psi).

If another number of slitting blades or a material with a higher or lower tensile strength is used the capacity of the CTL changes equivalently as illustrated on the capacity curves below.